:
MJG / MJGL
Grip type couplings are axially restrained, and a good alternative to welding, flange, grooved joint, union, etc.
MJG/MJGL have double grips which hold pipes tightly and make themnot move or separate from each other.
MJGP
Grip type couplings are axially restrained, and a good alternative to welding, flange, grooved joint, union, etc.
MGLP with single grip and thinner casing and gasket is good for low pressure pipe line at lower cost.
MJET
Because elbow/tee is arc shaped, other methods (socket, grooved joint, union, coupling, etc.) need the end of elbow/tee and pipe to be grooved, threaded, or welded in order to be connected.MJET is the world’s first coupling to connect pipe to elbow/tee without preprocessing
* Assembly type saves work time.* Couplings can connect pipes of different material.* Using a wrench to install eliminates worry about fire.* Stainless steel design is much lighter than cast iron product and saves manpower and cost.* No preprocessing is required at pipe ends.* Installation is done at one side. It enables products to be stored or work to be done at a narrow area.* Rubber gasket accommodates vibration, impact, noise, angular deflection, and distance between pipe ends. This makes couplings seismic design.* Couplings can be assembled and disassembled several times.* Grip type couplings resist against axial movement.* Slip (flexible) type couplings allow pipe expansion and contraction.* Repair clamps provide semi-permanent repair with speed and no down time.
* Remove burrs and contaminants on pipe surface.* Tighten bolts little by little & alternately up to the torque rate on the label.If bolts are tightened over torque rate, they can be broken, while if done below torque rate, product performance would be lower than its capacity.* Pipes should be anchored and supported properly, conforming to the relevant industry standards.
Q : 당신은 무역 회사입니까 또는 제조업체입니까?
A : 우리는 공장입니다.
Q : 배달 시간은 얼마나됩니까?
A : 상품이 재고가있는 경우 일반적으로 5-10 일입니다. 상품이 재고가없는 경우 15-20 일이며, 수량에 따라 다릅니다.
Q : 샘플을 제공합니까? 무료입니까, 추가입니까?
A : 네, 샘플을 무료로 제공 할 수는 있지만 운임은 지불하지 않아도됩니다.
Q : 지불 조건은 무엇입니까?
A : 지불액 = 1000USD, 100 % 사전. 지불> = 1000USD, 사전에 30 % T / T, shippment 전에 균형.
다른 질문이 있으시면 아래로 연락하십시오.